OrcaSlicer An Introduction and How to Get Started Obico Knowledge Base

Prime Tower Orca Slicer. Orca Slicer 1.63 released Orca 3DDruck Forum The height of the prime tower: Since the principle of time-lapse is to take a snapshot after each layer is printed, the nozzle needs to be wiped on each layer, so the height of the time. I have already managed to change the filament correctly with a pyrga tower, the only detail is that I cannot find a way to remove the additional purge, since it makes an extrusion on top of the purge tower, how can I remove that additional extrusion ?

Just set up an M600 macro that will pause the print, park the toolhead, then retract the filament out of the nozzle so you can change it The Prime Tower have an hard limit to move and stop 15mm away to any border of the print area in the bed

Orca Slicer Potente generador de Gocde que es mucho más HTA3D

Prime volume: We cannot set the prime volume for time-lapse prime tower, it is only composed of two outer walls, the middle is hollow, and the depth is fixed Prime volume: We cannot set the prime volume for time-lapse prime tower, it is only composed of two outer walls, the middle is hollow, and the depth is fixed But if you don't want to use it, in the 'others' section of the settings there's a toggle (in addition to the ability to set its size)

Prime tower? 8 by 3DTech Bambu Studio Bambu Lab Community Forum. Unofficial space for Orca Slicer users to discuss settings, features and tips. Orca bot: this issue is stale because it has been open for 90.

Manual Filament Tuning on Bambu Lab Printers with Orca Slicer! YouTube. The Prepare tab does not take in to account the brim width of the Prime tower, but this doesn't should block the movement of the Prime tower. Tried flush mm3 from 0-100 in flush volume calc, filament minimum purge in filament settings, and prime volume under prime tower settings with the only change is adding to the oversize first filament prime